Ethernet Splitter

If you possess multiple computers at home or atNow use the 110 Punch Down Mechanism to press
work, more likely you will want to share the internetdown the other end to the RJ-45 keystone jacks
connection between all the PC's so that all the usersand use the other end of the cable and cut it to 9
can use the internet at the same time. For thisinches and press down the four pairs with this wiring
purpose you can employ an ethernet splitter tocode, Jack #1: 1 White/Orange to pin 1keystone jack
construct a set of connections where all the PC's can2 Orange to pin 2 keystone jack 3 White/Green to
be linked to utilize the internet connection. So thepin 3 keystone jack 6 Green to pin 6 keystone jack
network is simply all the computers linked by a#2: 4 Blue to pin 2 keystone jack 5 White/Blue to pin
communications device which allows communicating1 keystone jack 7 White/Brown to pin.
resources between all the users.Use the preceding instructions to make one more
If it is not easy for you to get an Ethernet splitter,splitter so you eventually have two splitters. Plug one
then you can read this article to understand how yousplitter to the RJ45 wall plate and plug the two PC's
can make one by yourself. But it requires time,to the splitter. Now connect the other splitter to the
patience and a little knowledge of wiring. By settingpatch plate and plug two patch cables from the
up an Ethernet splitter, you will be able to connectsplitter to two free Ethernet cables from the switch.
two or more PC's simultaneously on one EthernetIf your splitter connections are right then the two
device.links from the knob on which the patch cable are
In order to make your own Ethernet splitters you willjoint should turn on. After this setup is complete,
need some devices and tools such as two RJ45then you will be able to install two PC systems all at
Crimpable Plug, four RJ-45 keystone jack, a smallthe same time connected using only one Ethernet
Ethernet Cable Scrap approximately 2 feet in lengthcord. This method is similar to Power over Ethernet
and tools like a RJ45 Crimp Tool Craft knife, 110but instead of injecting DC, it is injecting another
Punch Down Mechanism, Loctite  Super Glue.data. It is better if you can to draw one more
initially you will need to crease the RJ45 Plug to theEthernet cord from the patch panel to the wall plate.
Ethernet cable. For this to be done you will need toOnce you use these guidelines then you should
read a configuration scheme taken from a hardwarecreate a successful Ethernet splitter, if not you will
book or from the directions on the package.need to start over the procedure all over again.